EasyManuals Logo

Labrie expert 2000 Service Manual

Labrie expert 2000
172 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #19 background imageLoading...
Page #19 background image
9Expert(t) 2000
TM
Maintenance Manual
2. Turn the pump switch on the
console (PTO switch) to the
OFF
position.
3. Stop the engine.
4. Remove the key from the ignition
switch.
5. Put the key in a safe controlled
area.
6. Put adhesive tape on the ignition
switch keyhole.
Note:If the Expert(t) 2000
TM
is
equipped with a master switch
on the battery set, you must
turn it off. See Figure 3.
“Master switch location” .
Figure 3. Master switch location
7. Put an “Off Service” tag on all
steering wheels.
8. Put an “Off Service” sign in the
windshield.
9. Block any system that could
move by gravity with a proper
and visible safety prop (open
tailgate, raised body, etc.)
10. Release any residual pressure
from the hydraulic and
pneumatic system. Refer to “Air
Tank Draining Procedure” on
page 30 for details.
11. Move all control levers to release
any residual pressure from the
system.
12. Chock wheels on both sides to
prevent the vehicle from moving.
13. Disconnect the following items if
any type of welding is required:
•Battery
1
ABS module (anti-lock
brake system)
1
Electronic transmission
(ECU)
1
Electronic engine module
(ECM)
1
Intermittent wiper module
1
Master Switch
1. Refer to the chassis manufacturer
service manual to locate electronic
components.

Table of Contents

Other manuals for Labrie expert 2000

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Labrie expert 2000 and is the answer not in the manual?

Labrie expert 2000 Specifications

General IconGeneral
BrandLabrie
Modelexpert 2000
CategoryUtility Vehicle
LanguageEnglish

Related product manuals