EasyManuals Logo

Labrie expert 2000 Service Manual

Labrie expert 2000
172 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #67 background imageLoading...
Page #67 background image
57Expert(t) 2000
TM
Maintenance Manual
Figure 84. View from behind the
packer when fully retracted
Wear Pads Replacement
Replacement of the wear pads at the
top of the packer is required when
vertical movement of the packer is
greater than 3/16” (check with a pry
bar).
This section will provide the full
procedure to remove and change both
wear pads at the top of the packer.
Apply the following procedure to
remove and replace the wear pads:
1. Make sure the parking brake is
applied and the vehicle is tagged
out for maintenance purposes
(refer to “Lockout/Tagout
Procedure” on page 8);
2. Start the engine and engage the
hydraulic pump;
3. Disable the speed-up system on
the console (Figure 85. “In-cab
console from right-hand side
driving position”) by pulling out
the
SPEED-UP INHIBITOR switch;
Figure 85. In-cab console from
right-hand side driving position
DANGER
APPLY THE LOCKOUT/TAGOUT
PROCEDURE
TO PREVENT ANY ENGINE
START
-UP.
DANGER
NEVER CLIMB IN THE HOPPER WHILE
THE
ENGINE IS RUNNING.
Speed-Up
Inhibitor
Switch

Table of Contents

Other manuals for Labrie expert 2000

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Labrie expert 2000 and is the answer not in the manual?

Labrie expert 2000 Specifications

General IconGeneral
BrandLabrie
Modelexpert 2000
CategoryUtility Vehicle
LanguageEnglish

Related product manuals