EasyManuals Logo

Labrie expert 2000 Service Manual

Labrie expert 2000
172 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #58 background imageLoading...
Page #58 background image
48 CHAPTER 3
Maintenance
about three to four seconds. A
continuous red light on the LED
appears;
Figure 64. Multi-cycle settings
switch
7. Press the button the number of
times you want the packer to
cycle at a time.
Note:The module has been set at
the factory to three cycles.
Once you have entered the
desired number of cycles, the
LED flashes red/green the same
number of times to confirm you
the new settings have been
stored;
8. On the control station or the
right-hand side console, press
the green
START CYCLE button to
test the new settings of the
packer multi-cycle module;
Figure 65. Right-hand side control
station
9. If the packer performs the
desired number of cycles,
re-install the side panel. The
vehicle is ready to use the new
settings.
Note:For any other issues
concerning the multi-cycle
module, please contact the
Labrie Customer Support
Center.
Limit Switches
Adjustment
The packer limit switches were
properly adjusted at the factory for
optimal operation of the packer. If a
daily cleaning is not properly done
behind the packer, it is possible that
the limit switches no longer stop the
Settings switch
Emergency
Stop Button
Start
Cycle
Button

Table of Contents

Other manuals for Labrie expert 2000

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Labrie expert 2000 and is the answer not in the manual?

Labrie expert 2000 Specifications

General IconGeneral
BrandLabrie
Modelexpert 2000
CategoryUtility Vehicle
LanguageEnglish

Related product manuals