Labrie expert 2000 - Packer Cylinder Replacement

76 CHAPTER 3
Maintenance
Packer Cylinder
Replacement
To remove the packer cylinder,
apply the following procedure:
1. Make sure the parking brake is
applied and the vehicle is tagged
out for maintenance purposes
(refer to “Lockout/Tagout
Procedure” on page 8);
2. Start the engine and engage the
hydraulic pump;
3. Disable the speed-up system on
the console (Figure 116. “In-cab
console from right-hand side
driving position”) by pulling out
the
SPEED-UP INHIBITOR switch;
Figure 120. In-cab console from
right-hand side driving position
4. Using the
PACKER CONTROL
S
ELECTOR switch on the console,
select the right-hand side packer
control station (see Figure 117.
“Packer control selector switch”).
Note:This switch is found only on
vehicles equipped with
multiple packer control
stations.
Figure 121. Packer control selector
switch
DANGER
APPLY THE LOCKOUT/TAGOUT
PROCEDURE
TO PREVENT ANY ENGINE
START
-UP.
DANGER
NEVER CLIMB IN THE HOPPER WHILE
THE
ENGINE IS RUNNING.
Speed-Up
Inhibitor
Switch
Packer Control
Selector