73Expert(t) 2000
TM
Maintenance Manual
14. Check for even contact of wear
pad with the packer and follower
panels.
Arm Doghouse Panel
Scraper Removal and
Wear Pad Replacement
Units equipped with an automated
Helping Hand
TM
arm are equipped with
an arm doghouse panel scraper
preventing refuse build-up in front of
the packer cylinder.
To remove the arm doghouse panel
scraper and replace the wear pad,
apply the following procedure:
1. Make sure the parking brake is
applied and the vehicle is tagged
out for maintenance purposes
(refer to “Lockout/Tagout
Procedure” on page 8);
2. Start the engine and engage the
hydraulic pump;
DANGER
APPLY THE LOCKOUT/TAGOUT
PROCEDURE
TO PREVENT ANY ENGINE
START
-UP.
DANGER
NEVER CLIMB IN THE HOPPER WHILE
THE
ENGINE IS RUNNING.