135Expert(t) 2000
TM
Maintenance Manual
TROUBLESHOOTING
This section of the guide gets you
through some of the typical
troubleshooting procedures to be
performed on the Expert(t) 2000
TM
.
Troubleshooting the Expert(t) 2000
TM
is
a process where, in the event of a
failure, malfunction, or breakdown, you
will inspect and spot its causes and
then proceed to accordingly apply a
solution.
Note:Only qualified staff must be
allowed to perform
troubleshooting tasks on the
Expert(t) 2000
TM
.
TROUBLESHOOTING GUIDE
IMPORTANT
YOU MUST ENSURE THAT ALL
SAFETY
FEATURES ARE
CORRECTLY
LOOKED AT AND ALL
RELATED
PROCEDURES ARE
APPLIED
, SUCH AS THE
LOCKOUT/TAGOUT. REFER TO
“LOCKOUT/TAGOUT
PROCEDURE” ON PAGE 8 FOR
DETAILS
.
Problem Possible cause(s) Solution(s)
Insufficient packing
ratio
Low oil pressure Perform the hydraulic
pressure adjustment
procedure.
The packer hydraulic
cylinder is internally
bypassing.
Call the Labrie Customer
Support Center. Refer to
“Hydraulic Cylinder
Inspection Procedures” on
page 88 for details.
Defective pump Replace the pump.