EasyManuals Logo

Labrie expert 2000 Service Manual

Labrie expert 2000
172 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #146 background imageLoading...
Page #146 background image
136 CHAPTER 5
Troubleshooting
Problem Posible cause(s) Solution(s)
The hydraulic oil is
over heating
(temperature
higher than 180°F
or 77°C)
The oil level in the
hydraulic tank is too low.
Add oil to the tank upto the
required level. Refer to
“Hydraulic Oil” on
page 123.
Hydraulic pressure is either
too low or too high.
Perform the hydraulic
pressure adjustment
procedure.
The oil doesn’t have the
proper grading (i.e. too thin
in hot temperatures and
too thick in cold
temperatures).
See “Recommended
lubricants” on page 123 to
find out about the proper
type of oil to use. Refer
also to “Hydraulic Oil
Replacement Procedure”
on page 92.
Contaminated oil Change the return filter.
Restrictions in the
hydraulic system
Check all hydraulic
components that may have
the presence of debris
causing restrictions in the
system. Have the pump
inspected by a specialist.

Table of Contents

Other manuals for Labrie expert 2000

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Labrie expert 2000 and is the answer not in the manual?

Labrie expert 2000 Specifications

General IconGeneral
BrandLabrie
Modelexpert 2000
CategoryUtility Vehicle
LanguageEnglish

Related product manuals