EasyManuals Logo

Labrie expert 2000 Service Manual

Labrie expert 2000
172 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #80 background imageLoading...
Page #80 background image
70 CHAPTER 3
Maintenance
Packer Roller
Replacement
Packer rollers need to be replaced
when damaged or showing excessive
wear or flat spots.
To replace the packer rollers, apply
the following procedure:
1. Make sure the parking brake is
applied and the vehicle is tagged
out for maintenance purposes
(refer to “Lockout/Tagout
Procedure” on page 8);
2. Fully retract the packer;
3. Stop the engine.
4. Remove the front covers over
the cylinder pins;
5. Unbolt the roller assembly;
6. Clean the roller axle;
7. Grease the new roller assembly;
8. Bolt the assembly in place;
9. Put the front covers back on the
cylinder pins;
10. Check full cycle for smooth
operation.
DANGER
APPLY THE LOCKOUT/TAGOUT
PROCEDURE
TO PREVENT ANY ENGINE
START
-UP.
DANGER
NEVER CLIMB IN THE HOPPER WHILE
THE
ENGINE IS RUNNING.

Table of Contents

Other manuals for Labrie expert 2000

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Labrie expert 2000 and is the answer not in the manual?

Labrie expert 2000 Specifications

General IconGeneral
BrandLabrie
Modelexpert 2000
CategoryUtility Vehicle
LanguageEnglish

Related product manuals