EasyManuals Logo

Labrie expert 2000 Service Manual

Labrie expert 2000
172 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #46 background imageLoading...
Page #46 background image
36 CHAPTER 3
Maintenance
9. Open the clean-out trap door on
both sides of the hopper;
Figure 39. Clean-out trap door
10. Clean all accumulated dirt under
the cylinders and in the side
tracks using a hoe and a water
jet if necessary.
11. Clean out the rest of the
Expert(t) 2000
TM
body.
Note:Perform a visual inspection of
the hopper area, checking for
possible leaks in the hydraulic
system and wear on the
mechanical parts.
12. Exit the hopper;
13. Using the hoe, rake small pieces
of garbage out of the clean-out
trap;
14. Clean the area with a water jet;
15. Close the clean-out trap doors;
16. Start the engine;
17. Engage the hydraulic system;
18. Fully retract the packer;
19. Retract the arm along the
hopper.
On Manual-collection
and Cart-tipper-
equipped Units
To clean the hopper on an Expert(t)
2000
TM
not equipped with a Helping
Hand
TM
, apply the following
procedure:
1. Park the Expert(t) 2000
TM
on level
ground, in an area where small
DANGER
APPLY THE LOCKOUT/TAGOUT
PROCEDURE
TO PREVENT ANY ENGINE
START
-UP.
CAUTION
DO NOT USE THE WATER JET DIRECTLY
ON
CONNECTORS OR BATTERY FUSES.

Table of Contents

Other manuals for Labrie expert 2000

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Labrie expert 2000 and is the answer not in the manual?

Labrie expert 2000 Specifications

General IconGeneral
BrandLabrie
Modelexpert 2000
CategoryUtility Vehicle
LanguageEnglish

Related product manuals