37Expert(t) 2000
TM
Maintenance Manual
debris can fall on the ground for
further collection.
2. Apply the parking brake.
3. Using the
PACKER CONTROL
S
ELECTOR switch on the console,
select the right-hand side packer
control station (see Figure 33.
“Packer control selector switch”).
Note:This switch is found only on
vehicles equipped with
multiple packer control
stations.
Figure 40. Packer control selector
switch
4. Disable the speed-up system on
the console (see Figure 41.
“Main console from right-hand
side driving position”) by pulling
out the
SPEED-UP INHIBITOR switch;
Figure 41. Main console from
right-hand side driving position
5. Raise the crusher panel (see
Figure 42. “Hopper”) using the
lever located on the main
hydraulic valve (see Figure 43.
“Crusher panel lever”);
Figure 42. Hopper
Packer Control
Selector
Speed-Up
Inhibitor Switch
Crusher Panel