EasyManuals Logo

Labrie expert 2000 Service Manual

Labrie expert 2000
172 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #44 background imageLoading...
Page #44 background image
34 CHAPTER 3
Maintenance
chassis and options are
installed on the vehicle (i.e.
crusher panel, comingled
body, glass compartment,
automated arm type, etc.)
On Helping
Hand
TM
-equipped Units
To clean the hopper on a Helping
Hand
TM
-equipped Expert(t) 2000
TM
,
apply the following procedure:
1. Park the Expert(t) 2000
TM
on level
ground, in an area where small
debris can fall on the ground for
further collection.
2. Apply the parking brake.
3. Using the
PACKER CONTROL
S
ELECTOR switch on the console,
select the right-hand side packer
control station (see Figure 33.
“Packer control selector switch”).
Note:This switch is found only on
vehicles equipped with
multiple packer control
stations.
Figure 33. Packer control selector
switch
4. Disable the speed-up system on
the console (see Figure 34.
“Main console from right-hand
side driving position”) by pulling
out the
SPEED-UP INHIBITOR switch;
Figure 34. Main console from
right-hand side driving position
DANGER
ALWAYS WEAR GLOVES, SAFETY
BOOTS
, SHIRT, FULL-LENGTH PANTS
AND
SAFETY GLASSES WHEN CLEANING
THE
HOPPER AND BODY.
Packer Control
Selector
Speed-Up
Inhibitor Switch

Table of Contents

Other manuals for Labrie expert 2000

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Labrie expert 2000 and is the answer not in the manual?

Labrie expert 2000 Specifications

General IconGeneral
BrandLabrie
Modelexpert 2000
CategoryUtility Vehicle
LanguageEnglish

Related product manuals