Introduction 3
Multiplexed System
All MINIMAX™ vehicles are equipped with an electronic monitoring system called the multiplexed
system.
The multiplexed system used by Labrie is a CAN-based system that integrates a monitor, a control
panel and three electronic controllers. This whole system has been designed to help you operate your
unit in an efficient and easy way.
NOTE: Maintenance personnel as well as in-the-field technicians who encounter any problems with
the multiplexed system should refer to the Multiplex Diagnostic Manual (part# 153145-01) for
troubleshooting information and guidelines.
Service and Maintenance on the MINIMAX™
Maintenance on the MINIMAX™ is of paramount importance to ensure long-lasting durability of all its
moving parts as well as optimum performance in heavy work. Maintenance has to be done on almost
every system involved in the operation of the M
INIMAX™, such as the hydraulic, electrical and
mechanical systems. Some parts are subjected to more wear and tear than others. Therefore, these
parts need regular maintenance and routine check-up to prevent signs of deterioration as soon as
possible.
NOTE: Any time you have a problem with a Labrie unit, you should contact your Labrie authorized
dealer first. They should be able to provide you with the proper help that you need, whether it
is for parts or technical service.
In this manual you will find the most common maintenance and inspection procedures required for
the M
INIMAX™.
Parts
Labrie refuse vehicle parts are offered exclusively through LabriePlus and LabriePlus authorized
dealers. The quality and reliability of Labrie parts are second to none in the industry.
Warning
Your MINIMAX™ unit MUST BE COMPLETELY LUBRICATED before its first use. Refer to the
lube chart near the hopper on the curbside to know where the lubrication points are located on the
vehicle and how often the parts should be lubricated.
Initial lubrication carried out by Labrie Enviroquip Group is sufficient for production and transport
purposes ONLY.
With your safety in mind, we would like to remind you that ONLY QUALIFIED MECHANICS
should service the hydraulic, electrical, and pneumatic systems on your side loader. In addition, they
should also be fully knowledgeable in the operation of this unit. Please read the Operator Manual
prior to attempting any maintenance work on your M
INIMAX™ unit.