34 General Maintenance
Removing the Packer
The following procedure details how to remove the packer for maintenance purposes.
To remove the packer:
1. Ensure the parking brake is applied.
2. Start the engine and engage the hydraulic system.
3. Remove the tailgate safety pins (see Figure 3-15) and fully open the tailgate by pressing the
T
AILGATE UP switch on the control panel (see Figure 3-16).
Figure 3-15
Safety pin
Figure 3-16
Tailgate Up switch
4. Place the tailgate safety prop in service position (see Figure 3-17).
To Next Page
Loading...
Need help?
General
