Laser 128 - End

BASIC COMMANDS AND STATEMENTS
3.12 END
Purpose: Finishes program execution and
returns you to command level.
Format: END
Comments: This command may be placed
anywhere in your program -
though it may not be all that
useful as the first statement of
your program.
Example:
END is the most orderly way to
stop your BASIC program when
it has done what you require.
This is because, unlike the
similar command STOP, it does
not cause a BREAK mesage to
be displayed.
However, END is not essential
at the end of a BASIC program -
you will be returned to
command level when it finishes
anyway.
] 60 IF FIN < 0 THEN GOTO 80
] 70 END
] 80 •
•
•
In this example, if FIN is less
than zero, then the program
branches to line number 80.
II-37