Laser 128 - Rot

3.52 ROT
Purpose:
BASIC COMMANDS AND STATEMENTS
To specify the angle by which a
shape drawn by either DRAW or
XDRA W commands will
ROTate.
Format: ROT =an gle
Comments: For shapes drawn using the
DRAW shape commands, the
value given as angle can be
anything between 0 and 25~,
with 25? representing a 360°
rotation.
Example:
For shapes drawn using the
shape table method, a value of
16 for angle will rotate a shape
through one right angle (90°); 32
will rotate it through two right
angles (180° ); 48 will rotate it
through three right angles (270°
); and 64 (=4 x 16) will perform
a complete rotation, bringing it
back to its original position.
See DRAW command for an
example on ROT.
II-87