Laser 128 - Serial Printer Commands

6.1.2.2
CTRL-1 Z:
CTRL-1 c:
INPUT/OUTPUT PORTS
"ZAP" mode: Don't check
for any more commands.
Insert carriage returns
whenever the line width (set
by CTRL-1 nnnN) is
exceeded.
Serial printer commands
When the seria l printer is activated, the
computer will recognize the following serial
printer commands:
CTRL-1 "c":
CTRL-1 I:
Change the printer
command "lead -in" character
from CTRL-1 to the control-
character "c".
Ec ho the text being prin t ed
back to the screen. If the
line - width of the printer is
greater than that of the
current t ext disp l ay (eit h er
40-col umn or 80-column) ,
then echoing may cause
problem with the print-out.
CTRL-1 nnnN: Turn off screen-echoing and
set the printer line-width to
"nnn", where "nnn" is a
decimal number from 0 to
255. For example, CTRL-1
80N sets the line-width to
80 column . CTRL-1 ON sets
·"no" line-width.
1-55