Doc No. FM0410 issue N Page 3
Read and understand these instructions before commencing an installation.
Keep these instructions for future reference.
To reduce the risk of electric shock, do not disassemble this product unless you are qualified.
Opening or removing covers may expose you to dangerous voltages or other hazards.
No user serviceable parts inside.
Refer all servicing to qualified service personnel.
This product should only be connected to a 220-240VAC 50/60Hz mains supply.
If you are unsure of the type of power supply consult your local power company.
Danger of explosion if the internal batteries are incorrectly replaced.
Use only manufacturer approved rechargeable batteries as identified in this manual.
Only use manufacturer approved cable during installation.
Refer to this manual for cable types, recommended colour codes and cable length restrictions.
This product should be located at least 2 metres away from other electronic equipment.
Failure to provide this separation may result in reduced radio range of Telecare products.
Do not locate this product above a radiator or other heat source.
Do not expose to direct sunlight.
Do not expose this product to dripping or splashing water. As with any electronic equipment take care
not to spill liquids into any part of the system. Liquids can cause a failure and/or a fire hazard.
Clean with a hard-surface disinfectant wipe or a damp cloth and a non-abrasive cleaning product.
Polish with a dry duster. DO NOT use a wet cloth.
Avoid using harsh, abrasive or corrosive cleaning agents or detergents (e.g. scouring powders,
bleaches, polishes, etc.) when cleaning this product.
At the end of its life this product should be disposed of and recycled in accordance with the
environmental regulations. See the Regulatory Information in section 3 below.
To Next Page
Loading...
Need help?
General
