LEGRAND tynetec Advent XT - Amendments Record

Doc No. FM0410 issue N Page 63
51. AMENDMENTS RECORD
The table below lists significant changes to this manual;
Issue
Amendments
Date
A
Connection details for hard of hearing strobe option added to door entry telephone.
03/04/06
B
169MHz Network Receivers and Door Open Alarm connection details added. Controller requires V1.03a
firmware for 169MHz Network Receivers.
07/07/06
C
BT/Siemens DECT equipment changed to Kirk Telecom.
31/10/06
C-1
Programming information added for Kirk Telecom.
23/11/06
C-2
Door Panel connections amended for ESD mods and Kirk Distybase Duo programming updated.
19/12/06
D
Distybase configuration changed, Kirk 1500 option added, Door Panel changed to ZSD410, new issue
telephone board.
09/03/07
E
Distybase removed, Door Panel changed to ZSD411, ZXT121 MK2 Ethernet Interface added, V2.0 firmware
mods, issue H intercom, issue E PA Amp.
07/08/08
F
Normally closed Ceiling Pullcord added, ZSL045 Strobe Light added, Door Open Alarm changed to ZDA025,
ZXT340 Network Data Repeater added.
14/09/09
G
ZXT230 Apartment Station & Remote Control added.
24/03/10
H
Kirk 500/1500 DECT replaced by Kirk 300/6000. New ZFT220/221 Telephones. ZXT325 Network Receiver
RSSI information removed.
23/09/10
I
ZXT326 Zoned Network Receivers added (433MHz option removed). Number of Kirk 6000 Repeaters
reduced to 3 per Base Station. ZXT122 MK3 Ethernet Interface added.
04/07/11
J
New ZXT240-247 Combined Intercoms and ZXT315 Managers Display Panel added. Network Receiver link
options added.
10/01/12
J-1
Note added ref. intercom DIL switch 2 must be ON when an Advent xt strobe is connected.
07/06/12
K
New 2013 intercom range and new Kirk 400/6500 DECT added. Activity Monitor and Apartment Station
removed.
24/10/13
K-1
Earth connection added to Fortivoice IP PBX. IP 12 Channel Base Station can be P/No. ZXT546 or ZXT536.
New firmware V3.00D in firmware level report.
11/02/14
K-2
Combined intercom “Link Options” corrected; when a combined intercom has a remote intercom
connected move LK1 to “B” and leave LK2 in “A”.
07/08/14
K-3
Manager’s Panel is now provided with a battery backed 12V/2A PSU.
02/12/14
K-4
Manager’s Panel now shows the RS485 data cable drain wire connected to 0V on the Advent xt
termination board.
04/12/15
L
Kirk 4020/4040 & Butterfly DECT replaced by Spectralink 7202/7212
20/01/16
M
New V4.01 firmware. Digital Communicator added. Fortivoice PBX replaced by the Matrix. Caller ID Display
removed. Kick Switch input on Lift Callpoint.
16/03/17
M-1
BT Line Selector now shows the connection of an optional GSM Cellular Terminal.
22/09/17
N
Spectralink DECT removed. ZXT290 BLE Combined Intercom added. Revisions in-line with XT2.
20/09/19