Leibinger JET3 up - Page 50

50
Service Manual JET3
11020
11020=Nozzle has not been
closed
1. Print head mechanism stuck with ink.
2. Motor defective
3. Motor connector loose
Clean the print head with solvent..
Check if the connector of nozzle
motor is loose.
Change the nozzle motor
See the service document “cleaning
print head of JET3up”.
11025
11025=Nozzle could not be
opened
1. Print head mechanism stuck with ink.
2. Motor defective
3. Motor connector loose
Clean the print head with solvent.
Check if the connector of nozzle
motor is loose.
Change the nozzle motor.
See the service document “cleaning
print head of JET3up”.
11030
11030=No phasing
The time distance between the individual
print outs is too short
Increase the print go delay to get
more time between two prints.
Reduce the production speed if
possible.
11035
11035=Job could not be
loaded
Job could not be loaded.
The print job is physically
damaged or does not exist.
11040
11040=Printstart not
possible
Start print not possible.
1. Printer is not ready for printing.
2. Head cover is open
3. Nozzle is closed
Check if head-cover is on.
Check if nozzle is closed or open.
If closed, push button "nozzle
open"
11045
11045=Nozzle was open
already during Power On
process.
Nozzle was open during the power-on
process.
It is only an info message to
remind you that the printer has
been switched off with an open
nozzle. Possible that mains went
off or mains plug has been
removed while the nozzle has
been open.