5.Pressdownthesmallhandleonthemicroprocessorsocket,andthenpullthehandlealittlebitoutward
toreleaseitfromthesecuredposition.Then,gentlypressthemicroprocessorretainertoopenit.Ensure
thatthesmallhandleandthemicroprocessorretainerareinthefullyopenposition.
Figure98.Openingthehandleandmicroprocessorretainer
6.Removetheplasticmicroprocessorsocketcover.Storethemicroprocessorsocketcoverintheevent
thatyoulaterremovethemicroprocessorandneedthesocketcovertoprotectthepinsonthesocket.
Note:Donotdropanythingontothemicroprocessorsocketwhileitisexposed.Thesocketpinsmust
bekeptascleanaspossible.
Figure99.Removingthemicroprocessorsocketcover
7.Touchthestatic-protectivepackagethatcontainsthenewmicroprocessortoanyunpaintedsurfaceon
theoutsideoftheserver.Then,removethenewmicroprocessorfromthepackage.
Chapter6.Installing,removing,orreplacinghardware159
To Next Page
Loading...
