Step 2: Set up a rack
Install your system in a 4-post rack or Lenovo system rack, as applicable. If you are setting up a new rack for
the storage array, follow instructions that come with the rack.
Step 3: Install rails
When shipped, each shelf includes rack-mounting hardware. For detailed instructions on installing the rails,
refer to the installation manual that comes with the rail kit.
Step 4: Connect cables
The Installation and Setup Instructions include instructions for connecting cables. If you need lists of
supported cables and transceivers, best practices for cabling, and detailed information about the host ports
for your controller, refer to “Cabling your storage system ” on page 24.
Step 5: Configure hosts
To make storage available to a host, refer to one of the following to configure the host depending on the
host's operating system type:
• “Windows express configuration” on page 32
• “VMware express configuration” on page 49
• “Linux express configuration” on page 64
Step 6: Configure storage
To configure storage, you can access the web-based interface, ThinkSystem System Manager, by pointing a
browser to the controller's IP address. A setup wizard helps you get started with system configuration. As an
alternative, you can also use the command line interface (CLI). Select the interface you want to use:
• ThinkSystem System Manager online help
• Command Line Interface (CLI) Reference
Cabling your storage system
You can cable a host directly to a controller or use switches to connect a host to a controller. If your storage
system includes one or more drive shelves, you must cable them to your controller shelf. You can add a new
drive shelf while power is still applied to other components of the storage system. In addition, you can
connect your storage system to a network for out-of-band management.
Overview and requirements
Learn about the cabling requirements and considerations for DE Series controller shelves and supported
drive shelves.
When to use this information
This information is intended for a hardware installer or system administrator who is installing or expanding a
storage system. It is assumed that you have installed the storage system as described in the Installation and
Setup Instructions for your hardware.
Applicable hardware models
This information applies to the following hardware models:
• DE2000 series
• DE4000 series
• DE6000 series
24
ThinkSystem DE Series Hardware Installation and Maintenance Guide for 2U Enclosures
To Next Page
Loading...
Need help?
General