IOM/ESM firmware automatically upgrades to the latest version unless you have disabled the
upgrade feature.
The hot add procedure is complete. You can resume normal operations.
Ethernet cabling for a management station
You can connect your storage system to an Ethernet network for out-of-band storage array management.
You must use Ethernet cables for all storage array management connections.
Direct topology
A direct topology connects your controller directly to an Ethernet network.
Note: You must connect management port 1 on each controller for out-of-band management and leave port
2 available for access to the storage array by technical support.
Direct storage management connections
Switch topology
A switch topology uses a switch to connect your controller to an Ethernet network.
Note: You must connect management port 1 on each controller for out-of-band management and leave port
2 available for access to the storage array by technical support.
Chapter 2. System setup and configuration 31
To Next Page
Loading...
