Recording SAS-specific information for VMware
Record your protocol-specific storage configuration information on the SAS worksheet. You need this
information to perform provisioning tasks.
SAS worksheet - VMware
You can use this worksheet to record SAS storage configuration information. You need this information to
perform provisioning tasks.
Host Identifiers
Callout
No.
Host (initiator) port connections
SAS address
1 Host not applicable
2
Host (initiator) port 1 connected to Controller A,
port 1
3
Host (initiator) port 1 connected to Controller B,
port 1
4
Host (initiator) port 2 connected to Controller A,
port 1
5
Host (initiator) port 2 connected to Controller B,
port 1
Target Identifiers
Recommended configurations consist of two target ports.
Mappings Host
Mappings Host Name
Host OS Type
Discover storage on the host
After assigning volumes to the host, you perform a rescan so that the host detects and configures the
volumes for multipathing.
Chapter 2. System setup and configuration 63
To Next Page
Loading...
