Recording SAS-specific information for Windows
Record your protocol-specific storage configuration information on the SAS worksheet. You need this
information to perform provisioning tasks.
SAS worksheet - Windows
You can use this worksheet to record SAS storage configuration information. You need this information to
perform provisioning tasks.
Host Identifiers
Callout
No.
Host (initiator) port connections
SAS address
1 Host not applicable
2
Host (initiator) port 1 connected to Controller A,
port 1
3
Host (initiator) port 1 connected to Controller B,
port 1
4
Host (initiator) port 2 connected to Controller A,
port 1
5
Host (initiator) port 2 connected to Controller B,
port 1
Target Identifiers
Recommended configurations consist of two target ports.
Mappings Host
Mappings Host Name
Host OS Type
Discover storage on the host
LUNs on your storage system appear as disks to the Windows host. When you add new LUNs, you must
manually rescan the associated disks to discover them. The host does not automatically discover new LUNs.
Chapter 2. System setup and configuration 47
To Next Page
Loading...
