• You have completed the array side iSCSI configuration.
• You must know the IP address of each port on the controller.
These instructions assume that two NIC ports will be used for iSCSI traffic.
Step 1. Disable unused network adapter protocols.
These protocols include, but are not limited to, QoS, File and Print Sharing, and NetBIOS.
Step 2. Execute > iscsicpl.exe from a terminal window on the host to open the iSCSI Initiator Properties
dialog box.
Step 3. On the Discovery tab, select Discover Portal , and then enter the IP address of one of the iSCSI
target ports.
Step 4. On the Targets tab, select the first target portal you discovered and then select Connect.
Step 5. Select Enable multi-path, select Add this connection to the list of Favorite Targets, and then
select Advanced.
Step 6. For Local adapter, select Microsoft iSCSI Initiator.
Step 7. For Initiator IP, select the IP address of a port on the same subnet or VLAN as one of the iSCSI
targets.
Step 8. For Target IP, select the IP address of a port on the same subnet as the Initiator IP selected in the
step above.
Step 9. Retain the default values for the remaining check boxes, and then select OK.
Step 10. Select OK again as you return to the Connect to Target dialog box.
Step 11. Repeat this procedure for each initiator port and session (logical path) to the storage array that you
want to establish.
Chapter 2. System setup and configuration 43
To Next Page
Loading...
