Step 2. Connect the front VGA cable 1 , the USB cable 2 , and the operator-information-panel cable 3 to
the system board.
Figure 69. Front I/O assembly cable connection
After installing the front I/O assembly, complete the parts replacement. See “Completing the parts
replacement” on page 164.
Hot-swap power supply replacement
Use this information to remove and install a hot-swap power supply.
Remove a hot-swap power supply
Use this information to remove a hot-swap power supply.
“Read the
installation
Guidelines” on
page 53
“ATTENTION:
Static Sensitive Device
Ground package before opening”
on page 56
Chapter 3. Hardware replacement procedures 93
To Next Page
Loading...
