Step 3. Use the key to lock the security bezel to the closed position.
Figure 37. Locking the security bezel
Rack latch replacement
Use this information to remove and install the rack latches.
Depending on the server model, the rack latches might be assembled with a VGA connector, the front I/O
assembly, or both.
Note: Your rack latches might look different from the illustrations in this topic.
Remove the rack latches
Use this information to remove the rack latches.
“Read the
installation
Guidelines” on
page 53
“Power off
the server
for this task”
on page 13
“ATTENTION:
Static Sensitive Device
Ground package before opening”
on page 56
Before removing the rack latches:
1. If you have installed the security bezel, remove it. See “Remove the security bezel” on page 62.
2. Use a flat-blade screwdriver to remove the ID label plate on the right rack latch and place it in a safe
place.
Chapter 3. Hardware replacement procedures 65
To Next Page
Loading...
