Server models with eight 2.5-inch hot-swap drives
Use this section to understand the cable routing for server models with eight 2.5-inch hot-swap drives.
Note: Both 8i and 16i RAID adapters are supported in this configuration.
Figure 22. Cable routing for server models with eight 2.5-inch hot-swap drives
Cable
From To
1 SAS signal cable* SAS 0 and SAS 1 connectors on the
backplane
HBA/RAID adapter installed in PCIe
slot 4:
• Gen 3: C0C1
• Gen 4: C0
2 Power cable Power connector on the backplane Backplane power connector 1 on the
system board
Note: *When Gen 4 HBA/RAID adapter is installed, ensure you use Gen 4 SAS signal cable (ThinkSystem
SR550/SR590/SR650 2.5" SAS/SATA/AnyBay 8-Bay X40 RAID Cable Kit).
40 ThinkSystem SR550 Maintenance Manual
To Next Page
Loading...
