Figure 67. Front I/O assembly removal
Step 1. Remove the two screws that secure the front I/O assembly.
Step 2. Remove the front I/O assembly from the chassis.
If you are instructed to return the old front I/O assembly, follow all packaging instructions and use any
packaging materials that are provided.
Install the front I/O assembly
Use this information to install the front I/O assembly.
“Read the
installation
Guidelines” on
page 53
“Power off
the server
for this task”
on page 13
“ATTENTION:
Static Sensitive Device
Ground package before opening”
on page 56
Before you install the front I/O assembly, touch the static-protective package that contains the new front I/O
assembly to any unpainted surface on the outside of the server. Then, take the new front I/O assembly out of
the package and place it on a static-protective surface.
To install the front I/O assembly, complete the following steps:
Watch the procedure
A video of this procedure is available at
https://www.youtube.com/playlist?list=PLYV5R7hVcs-
C9jFjZnXQ6AmTXaIdX6_HJ
.
Chapter 3. Hardware replacement procedures 91
To Next Page
Loading...
