Figure 50. 2.5-inch hot-swap drive removal
Figure 51. 3.5-inch hot-swap drive removal
After removing a hot-swap drive:
1. Install the drive filler or a new hot-swap drive.
2. If you are instructed to return the old hot-swap drive, follow all packaging instructions and use any
packaging materials that are provided.
Install a hot-swap drive
Use this information to install a hot-swap drive.
“Read the
installation
Guidelines” on
page 53
“ATTENTION:
Static Sensitive Device
Ground package before opening”
on page 56
76 ThinkSystem SR550 Maintenance Manual
To Next Page
Loading...
