Lenovo ThinkSystem SR550 - Riser Card Replacement; Remove a Riser Card

Figure 79. Connecting the RAID super capacitor module to the RAID adapter
Complete the parts replacement. See “Complete the parts replacement” on page 164.
Riser card replacement
Use this information to remove and install a riser card.
Note: The following procedure is based on the scenario that the riser card is installed on the riser card
bracket 1. The procedure is similar for riser card installed on the riser card bracket 2.
Remove a riser card
Use this information to remove a riser card.
“Read the
installation
Guidelines” on
page 53
“Power off
the server
for this task”
on page 13
“ATTENTION:
Static Sensitive Device
Ground package before opening”
on page 56
Before removing a riser card, remove the top cover. See “Remove the top cover” on page 56.
To remove a riser card, complete the following steps:
Watch the procedure
A video of this procedure is available at
https://www.youtube.com/playlist?list=PLYV5R7hVcs-
C9jFjZnXQ6AmTXaIdX6_HJ
.
Step 1. Disconnect related cables.
Step 2. Grasp the riser assembly by its edges and carefully lift it straight up and off the chassis.
104
ThinkSystem SR550 Maintenance Manual