Server models with eight 3.5-inch hot-swap drives
Use this section to understand the cable routing for server models with eight 3.5-inch hot-swap drives.
Figure 18. Cable routing for server models with eight 3.5-inch hot-swap drives
Cable From To
1  SAS signal cable* SAS 0 and SAS 1 connectors on the 
backplane
HBA/RAID adapter installed in PCIe 
slot 4: 
•  Gen 3: C0C1
•  Gen 4: C0
2  Power cable Power connector on the backplane Backplane power connector 1 on the 
system board
Note: *When Gen 4 HBA/RAID adapter is installed, ensure you use Gen 4 SAS signal cable (ThinkSystem 
SR550/SR590/SR650 3.5" SAS/SATA 8-Bay X40 RAID Cable Kit).
34
ThinkSystem SR550 Maintenance Manual