Figure 15. System board LEDs
Table 11. LEDs on the system board
Callout Callout
1 System error LED 2 System ID LED
3 XCC heartbeat LED 4 Field-Programmable Gate Array (FPGA) error LED
5 System power LED
Internal cable routing
Some of the components in the server have internal cables and cable connectors.
To connect cables, observe the following guidelines:
• Power off the server before you connect or disconnect any internal cables.
• See the documentation that comes with any external devices for additional cabling instructions. It might
be easier for you to route cables before you connect the devices to the server.
Chapter 2. Server components 31
To Next Page
Loading...
