Table 1. Server specifications (continued)
Specification
Description
Internal drives
Front:
• Up to four 3.5-inch hot-swap SAS/SATA drives
• Up to four 3.5-inch hot-swap AnyBay (SAS/SATA/NVMe) drives
• Up to four 2.5-inch hot-swap SAS/SATA drives
• Up to eight 2.5-inch hot-swap SAS/SATA/U.3 NVMe drives
• Up to six 2.5-inch hot-swap SAS/SATA and four 2.5-inch hot-swap AnyBay (SAS/
SATA/NVMe) drives
• Up to six 2.5-inch hot-swap SAS/SATA and four 2.5-inch hot-swap NVMe drives
• Up to six 2.5-inch hot-swap SAS/SATA and two 2.5-inch hot-swap AnyBay (SAS/
SATA/NVMe) drives and two 2.5-inch hot-swap NVMe drives
• Up to ten 2.5-inch hot-swap NVMe drives
• Up to ten 2.5-inch hot-swap AnyBay (SAS/SATA/NVMe) drives
• Up to 16 hot-swap EDSFF drives
Inside:
• Up to two internal SATA or NVMe M.2 drives
Rear:
• Up to two 2.5-inch hot-swap SAS/SATA or NVMe drives
• Up to two 7mm hot-swap SATA or NVMe drives
Notes:
• M.2 and 7mm drives are not supported at the same time.
• If PMEM or 256 GB DIMM is used, rear 2.5-inch drives are not supported.
• For the server model with 16 front EDSFF drives, M.2 drives are not supported.
• For technical rules for drives, see “Technical rules for drives” on page 87.
Expansion slots
Depending on the model, your server supports up to three PCIe slots in the rear.
• PCIe x16, low-profile
• PCIe x16/x16, low-profile + low profile
• PCIe x16/x16, low profile + full-height
For locations and technical rules for PCIe slots, see “Rear view” on page 39 and
“Technical rules for PCIe adapters” on page 88.
Graphics processing unit
(GPU)
Your server supports the following GPUs:
• Low-profile, half-length, single-wide: NVIDIA
®
Tesla T4 16GB Base Card (for China
only), NVIDIA
®
Quadro
®
P620, NVIDIA
®
Tesla
®
T4
• Full-height, 3/4 length, single-wide: NVIDIA
®
Quadro
®
P2200
For technical rules for GPU, see “Technical rules for GPU adapters” on page 89.
Chapter 1. Introduction 5
To Next Page
Loading...
