Figure 65. Adapter installation (slots 5 through 8)
Step 1. Align the adapter with the I/O-tray slot and insert it; then, press the adapter into the I/O tray until the
connector is fully seated.
If you have no other operations to perform on the I/O tray after installing an adapter in slots 5 through 8:
1. If any of the adapters in the I/O tray have internal cables, make sure that they are connected before
installing the I/O tray.
2. Install the riser or riser filler for slots 1 through 4 (left riser). See “Install the riser for slots 1 through 4 (left
riser)” on page 176.
3. Install the I/O tray in the chassis and connect all cables. See “Install the I/O tray” on page 153.
Install a LOM adapter in slot 9
PCIe adapters in slots 5 through 8 and the LOM adapter in slot 9 are in the I/O tray that is accessed from the
rear of the server. With the I/O tray removed from the chassis, insert the adapter in the I/O tray.
S002
CAUTION:
The power control button on the device and the power switch on the power supply do not turn off the
electrical current that is supplied to the device. The device also might have more than one power
cord. To remove all electrical current from the device, ensure that all power cords are disconnected
from the power source.
Before you install a LOM adapter in slot 9, make sure that there is no filler installed in slot 9.
Appendix B. Component reference 119
To Next Page
Loading...
