S002
CAUTION:
The power control button on the device and the power switch on the power supply do not turn off the
electrical current that is supplied to the device. The device also might have more than one power
cord. To remove all electrical current from the device, ensure that all power cords are disconnected
from the power source.
CAUTION:
Make sure that all server power cords are disconnected from their power sources before performing
this procedure.
Before you remove the compute system board:
1. Remove the front cover. See “Remove the front cover” on page 139.
2. Remove compute tray where the compute system board is installed. See “Remove a compute tray” on
page 123.
3. If you are removing the lower compute system board in a compute tray, remove the upper compute
system board or compute system board filler first to access connectors on the lower compute system
board. See “Remove a compute system board filler” on page 129, as applicable.
Complete the following steps to remove the compute system board:
Watch the procedure. A video of the replacement process is available:
• Youtube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-DbSYJFY74PoKmph7vgrkKH&playnext=1
• Youku: http://list.youku.com/albumlist/show/id_50952215
Figure 72. Compute system board removal
Appendix B. Component reference 127
To Next Page
Loading...
