CAUTION:
Make sure that all server power cords are disconnected from their power sources before performing
this procedure.
Before you remove the compute system board filler:
1. Remove the front cover. See “Remove the front cover” on page 139.
2. Remove compute tray where the compute system board filler is installed. See “Remove a compute tray”
on page 123.
Complete the following steps to remove the compute system board filler:
Watch the procedure. A video of the replacement process is available:
• Youtube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-DbSYJFY74PoKmph7vgrkKH&playnext=1
• Youku: http://list.youku.com/albumlist/show/id_50952215
Figure 74. Compute system board filler removal
Step 1. Press the release clips and slide the compute system board filler out of the compute tray.
If you are instructed to return the compute system board filler, follow all packaging instructions, and use any
packaging materials for shipping that are supplied to you.
Install a compute system board filler
Install a compute system board filler by inserting it in the compute tray and pushing it in until it locks in place.
S002
CAUTION:
130
ThinkSystem SR950 Setup Guide
To Next Page
Loading...
