Figure 103. Riser for slots 10 through 15 (right riser) removal
Step 1. Loosen the two captive screws (items 1 in preceding figure) that secure the riser to the I/O tray
board.
Step 2. Lift the riser up and out of the I/O tray.
After you remove the riser:
• If you are removing the riser and are not installing a replacement:
1. Install the screw that secures the I/O tray board to the I/O tray (item 3 in the figure). This screw
replaces the captive screw on the rear edge of the riser below the midplane connectors. Screw
location is labelled “Remove screw before installing riser” on the I/O board.
2. Install the I/O-tray fillers in adapter slots 10 through 15 (item 4 in the figure).
If you are instructed to return the riser, follow all packaging instructions, and use any packaging materials for
shipping that are supplied to you.
Remove a riser bracket from slots 14 and 15
The riser bracket for slots 14 and 15 is attached to the slot 10 through 15 I/O tray riser that is accessed from
the rear of the server. After removing the I/O tray and the riser for slots 10 through 15 (right riser), release the
retaining clips and remove the bracket from the riser.
S002
CAUTION:
Appendix B. Component reference 173
To Next Page
Loading...
