Figure 106. Riser for slots 1 through 4 (left riser) installation
Step 1. Align the riser with the I/O tray and insert it; then, press the riser into the I/O tray until the connector
is fully seated.
Step 2. Tighten the two captive screws (items 4 in preceding figure) that secure the riser to the I/O tray
board.
If you have no other operations to perform on the I/O tray after installing the riser for slots 1 through 4, install
the I/O tray in the chassis and connect all cables. See “Install the I/O tray” on page 153.
Install the riser for slots 10 through 15 (right riser)
The riser for adapter slots 10 through 15 (right riser) is in the I/O tray that is accessed from the rear of the
server. After installing adapters in the riser, insert the riser in the I/O tray and secure it with two captive
screws.
S002
CAUTION:
The power control button on the device and the power switch on the power supply do not turn off the
electrical current that is supplied to the device. The device also might have more than one power
cord. To remove all electrical current from the device, ensure that all power cords are disconnected
from the power source.
Appendix B. Component reference 177
To Next Page
Loading...
