CAUTION:
Make sure that all server power cords are disconnected from their power sources before performing
this procedure.
Before you remove an upper storage interposer:
1. Remove the front cover. See “Remove the front cover” on page 139.
2. Remove the upper compute tray or storage tray. See “Remove a compute tray” on page 123 or
“Remove a storage tray” on page 187.
3. If you removed a compute tray and it has one or more compute system boards installed or a compute
system board filler, remove the compute system boards or compute system board filler. See “Remove a
compute system board” on page 126.
4. Turn the tray upside down and remove the upper fan cage. See “Remove a fan cage (upper tray)” on
page 131.
Complete the following steps to remove an upper storage interposer.
Watch the procedure. A video of the installation process is available:
• Youtube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-DbSYJFY74PoKmph7vgrkKH&playnext=1
• Youku: http://list.youku.com/albumlist/show/id_50952215
Figure 110. Upper storage interposer removal
Step 1. Disconnect all power and data cables from the storage interposer.
Step 2. Slide the RAID card forward to disconnect the RAID card from the storage interposer; then, rotate
the RAID card upward. (Leave the three cables connected to the RAID card.)
Step 3. Remove the screw securing the storage interposer in place.
Step 4. Slide the storage interposer to the left and remove it from the tray.
If you are instructed to return the storage interposer, follow all packaging instructions, and use any
packaging materials for shipping that are supplied to you.
182
ThinkSystem SR950 Setup Guide
To Next Page
Loading...
