Note: In this illustration, the image on the left shows the tray right-side up and the image on the right shows
the tray upside down.
Figure 19. Cable routing, SAS drive cables (upper tray with storage-board assembly)
Table 17. Cable routing, SAS drive cables (upper tray)
Cable
Routing
1 PCIe SAS interface
• From:
– Lower compute system board in upper compute tray, “PCIe/NVMe” connector
(see “System-board connectors” on page 103)
– Storage-board assembly in upper tray, “PCIe” connector (see “Storage-board-
assembly connectors” on page 103)
• To: Storage interposer, “PCIe” connector (see “Storage interposer connectors” on
page 107)
2 RAID interface for drive
backplane 4
• From: RAID card, “C3” connector (see “RAID card connectors” on page 108)
• To: Drive backplane, connector “SAS” (see “Drive backplane connectors” on page
109)
3 RAID interface for drive
backplane 5
• From: RAID card, “C2” connector (see “RAID card connectors” on page 108)
• To: Drive backplane, connector “SAS” (see “Drive backplane connectors” on page
109)
4 RAID interface for drive
backplane 6
• From: RAID card, “C1” connector (see “RAID card connectors” on page 108)
• To: Drive backplane, connector “SAS” (see “Drive backplane connectors” on page
109)
NVMe drive cables (upper tray)
Common drive cables are used by only NVMe drives.
Chapter 2. Server components 37
To Next Page
Loading...
