EasyManua.ls Logo

Lenovo ThinkSystem SR950 7X12 - Server Hardware Setup Procedures; Setup Checklist, Guidelines, and Static-Sensitive Device Handling

Lenovo ThinkSystem SR950 7X12
202 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
The parts listed in the following table are identified as one of the following:
Tier 1 customer replaceable unit (CRU): Replacement of Tier 1 CRUs is your responsibility. If Lenovo
installs a Tier 1 CRU at your request with no service agreement, you will be charged for the installation.
Tier 2 customer replaceable unit: You may install a Tier 2 CRU yourself or request Lenovo to install it, at
no additional charge, under the type of warranty service that is designated for your server.
Field replaceable unit (FRU): FRUs must be installed only by trained service technicians.
Consumable and Structural parts: Purchase and replacement of consumable and structural parts
(components, such as a cover or bezel) is your responsibility. If Lenovo acquires or installs a structural
component at your request, you will be charged for the service.
Table 19. Parts listing
Index Description
Tier 1 CRU Tier 2 CRU
FRU
Consuma-
ble and
Structural
part
For more information about ordering the parts shown in Figure 22 “Server components” on page 40:
http://datacentersupport.lenovo.com/us/en/products/servers/thinksystem/sr950/7X12/parts
1
Upper tray filler
2
Fan cage (upper)
2
Fan cage (lower)
3
Fan filler
4
Fan
5
Compute tray (upper)
5
Storage tray
6
Storage board assembly
7
Compute system board filler
8
Midplanes (five types)
9
Hard disk drive backplane
10
RAID flash power module
11
RAID flash power module bracket
12
Front USB/VGA assembly
13
Storage interposer
14
RAID card
15
Front operator panel
16
Compute tray (lower)
17
Compute system board
18
Processor
19
Processor and heat sink (PHM)
19
Heat sink
Chapter 2. Server components 41

Table of Contents

Related product manuals