CAUTION:
The power control button on the device and the power switch on the power supply do not turn off the
electrical current that is supplied to the device. The device also might have more than one power
cord. To remove all electrical current from the device, ensure that all power cords are disconnected
from the power source.
CAUTION:
Make sure that all server power cords are disconnected from their power sources before performing
this procedure.
Before you install an optional LOM adapter in slot 9:
1. If the I/O tray is installed in the server, remove it. See “Remove the I/O tray” on page 152.
2. Remove the riser for slots 10 through 15 (right riser) to access the adapter connectors in the I/O tray.
See “Remove the riser for slots 10 through 15 (right riser)” on page 171.
3. Make sure that there is no filler installed in slot 9.
Complete the following steps to install a LOM adapter in slot 9.
Watch the procedure. A video of the installation process is available:
• Youtube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-DbSYJFY74PoKmph7vgrkKH&playnext=1
• Youku: http://list.youku.com/albumlist/show/id_50952215
Figure 34. LOM adapter installation (slot 9)
Step 1. Attach the extension bracket to the top of the LOM adapter using two screws.
66
ThinkSystem SR950 Setup Guide
To Next Page
Loading...
