Lenz digital plus lh01 - Page 45

45
Action
Display
Explanation
Proceed from ‘Locomotive control’ (address
or speed step are displayed)…
… press the bottom of the rotary knob until
the LED at the bottom shines.
‘SYS’ is displayed, followed by the first sub
menu of the system settings.
Select ‘XN.ID’.
Press the bottom of the rotary knob. The
XpressNet address currently set is displayed
(the factory setting is address 3).
Turn to select the desired new XpressNet
address.
Press the centre of the rotary knob to confirm
your selection.
Turn to select another system setting or press
'Esc' to return to ‘Locomotive control’.