Lenz digital plus lh01 - Resetting Command Stations (LZV100;LZ100)

48 Information LH01
Press the centre of the rotary knob again to
reset the LH01. ‘OK’ is displayed.
You are now in the menu ‘Locomotive
control’. Address ‘0003’ is displayed.
13.5 Resetting command stations (LZV100/LZ100)
Select this option to reset the command station (LZV100 / LZ100).
Action
Display
Explanation
Proceed from ‘Locomotive control’ (address
or speed step are displayed)…
… press the bottom of the rotary knob until
the LED at the bottom shines.
‘SYS’ is displayed, followed by the first sub
menu of the system settings.
Select ‘Z.RST’.
Press the centre of the rotary knob to confirm
your selection. ‘Z.RST’ flashes as a last
warning before resetting. Press 'Esc' to
cancel the resetting process.
Press the centre of the rotary knob again to
reset the command station. You are now in
the menu ‘Locomotive control’.