13.8 Setting the club mode
What is the club mode?
Let us assume that you would like to operate your model railway
layout together with other model railway fans.
To this end, you would like to hand the manual control LH01 to
somebody who has never used the device. You can simplify
operation by hiding most of the operating functions.
Or you would like to prevent someone from selecting a locomotive that
was not assigned to him or her or from making other system settings.
To this end, three modes are available:
Mode 1: It is only possible to control the locomotive set and to
switch the functions assigned to function keys A, B and C.
It is also possible so switch points and signals.
All other operating functions of the LH01 are blocked.
Mode 2: It is only possible to control the locomotive set and to
switch the functions assigned to function keys A, B and C.
All other operating functions of the LH01 are blocked.
Mode 0: This is the factory setting. All settings and functions of the
LH01 are available.
Mode 1 and mode 2 are secured by a password (a 4-digit number).
This password is required to return to mode 0.
Note down the password!
If you forget the password, you will not be able to return to
mode 0.
If you forget the password, please contact our support
service.
To Next Page
Loading...
