13.10 Setting the brightness of the display
Proceed from ‘Locomotive control’ (address
or speed step are displayed)…
… press the bottom of the rotary knob until
the LED at the bottom shines.
‘SYS’ is displayed, followed by the first sub
menu of the system settings.
Press the bottom of the rotary knob. The
brightness value currently set is displayed.
The factory setting is 80%.
Turn the rotary knob to change the brightness
value. The result will be reflected in a change
in brightness.
Click the centre of the rotary knob to confirm
your selection.
To Next Page
Loading...
