18 Information LH01
8.2.1.1 ‘NEU’ is not displayed?
This means that all twelve slots of the stack are occupied by locomotive addresses. If
the stack is full, you will have to delete another locomotive address from the stack.
8.3 Deleting a locomotive address from the stack
Press the right side of the rotary knob until the
LED to the right shines. Press to display
‘ADR’.
Turn until ‘ENTF’ is displayed.
… and turn the rotary knob until the address
that you would like to delete is displayed.
Press the centre of the rotary knob to confirm
your selection.
The locomotive address to be deleted
flashes. Press 'Esc' to cancel the deletion
process.
Press the centre of the rotary knob again to
confirm the deletion. The next locomotive
address from the stack is displayed. You can
control the locomotive immediately.
If you delete a locomotive address from the stack, you will
also delete the assignments of the function keys for this
address.
If you re-enter the locomotive address into the stack, you
will have to re-assign the function keys (p. 24).
To Next Page
Loading...
