Multiple tractions that are already joined (by
means of the LH100 or LH90) can be controlled.
It is not possible to join a multiple traction with the
LH01.
Programming in
operational
mode (PoM)
PoM allows you to change the settings of the
locomotive that is currently being controlled. You
can change, for example, the starting delay,
maximum speed, or sound volume.
Changing a
locomotive
address
You can read or change a locomotive address on
the programming track of the LZV100.
Points, signals
and other
accessories
The address range for points, signals and other
accessories (for example, uncouplers) ranges
from 1 to 999.
Communication with the command station is
made through the XpressNet connection.
As is the case with all other XpressNet devices,
your LH01 can be disconnected and reconnected
during operation. The locomotive controlled last
will continue its operation with the last settings
stored. Once reconnected, this locomotive will
again be controlled.
W 70 mm x H 125 mm x D 38 mm
To Next Page
Loading...
Need help?
General
