Electrical installation
Devices in the power range 0.25 ... 2.2 kW (1/N/PE AC 230 V)
Terminal assignment of the power connections
6
l
174
EDS84ASC552 EN 8.1
6.3.2 Terminal assignment of the power connections
Preparing the cable installation
To connect the shield of the motor cable, use the shield lug of the rear shield sheet. Position
the shield sheet as follows:
1. Release the holding screw of the shield sheet.
2. Bring the shield sheet into the lock−in position.
3. Tighten the holding screw to lock the shield sheet.
8400GG011
Fig. 6−11 Locate shield sheet in position
Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: CustomerService@valin.com
To Next Page
Loading...
